Maintenance - Intermec ColorCoder 901 Install Manual

Intermec ColorCoder 901 – Installation Instructions
CUTTER, cont'd.
Printer Settings
Setting the Output Option
Setting up the printer to use the automatic cutter involves two
operations to be performed on the printer's control panel:
• Setting the output option to "Use".
• Setting the cut interval, i.e. number of labels printed between each
cutting operation.
Note that these settings will be deleted, unless they are saved using
a "NVRAM SAVE" operation, see the ColorCoder 901 User's
Manual.
After installing the cutter on the printer, turn on the power to the
1.
cutter.
Note that you must always turn on the power to the cutter before
you switch on the printer, since the printer's software can only
detect the presence of a cutter at power-up.
Turn on the power to the printer. A message appears on the
2.
display panel:
READY
Press the <On line> key.
3.
OFF LINE
Press the <Menu> key.
4.
PAPER TYPE
Press the <Cursor right> key four (4) times, until this message
5.
is displayed:

MAINTENANCE

Press the <Enter> key.
6.
TEST PRINT
Press the <Cursor right> key twice.
7.
PARAM. SET.
Continued!
6