Table of Contents
Advertisement
Intermec ColorCoder 901 – Installation Instructions
CUTTER, cont'd.
Setting the Cut Interval,
cont'd.
Set all digits. When the cursor is positioned at the extreme right
8.
digit of the value, press the <Cursor right> key and the cursor
disappears.
CUT INT.
Press the <Enter> key.
9.
MARGIN SET.
Press the <Menu> key repeatedly, until this menu is displayed:
10.
OFF LINE
Press the <On line> key.
11.
READY
You are now back at the "READY" menu and can start printing
12.
and cutting labels. However, remember that the cut interval
value will not be saved after power-off, unless you perform a
"NVRAM SAVE" operation as described in the ColorCoder
901 User's Manual.
Carry out printing and cutting operations using the "Test Print"
or "Mem. Card Print" routines described in the User's Manual,
using 102 x 76 mm (4 x 3") label paper. If the cutting does not
occur at the right place, e.g. between labels, you can adjust the
cutting position as described on next page.
=00025
Continued!
9
Advertisement
Table of Contents
