Intermec Trakker Antares 2480 Supplementary Manual page 2

Attaching a Terminal to the Desk-Mount Bracket
Bolt
To attach a terminal to the desk-mount bracket
1. Move the arms to a 90-degree angle from the base.
2. Put the adhesive feet on the base or secure the base to a surface using the
bolt holes in the base as a template.
3. If you received your desk-mount bracket with your terminal, do not connect
the power supply, serial port cables, input device, Ethernet cable, or any
relay wires until you have attached the terminal to the bracket.
If you received your bracket after your terminal, disconnect the cables and
wires. The badge scanner cable can remain connected if the cable fits snugly
against the bottom edge of the rear enclosure. For help disconnecting the
cables and wires, see your TRAKKER Antares 248X Stationary Terminal
User's Manual (Part No. 066960).
Mounting screw
(5 places)
Cable
Nut
organizer
(2 places)
Left
arm
Rubber
washer
248XI.001
Nut
(2 places)
Power supply
holder
Right arm
Badge scanner
cable notch
Arm
brake
Base
Knob