Safety; Introduction; Symbols; Intended Use - MAHA MSD 3000 Original Operating Instructions

1

Safety

1.1

Introduction

Thoroughly read this manual before operating the equipment and comply with
the instructions. Always display the manual in a conspicuous location.
Personal injury and property damage incurred due to non-compliance with these
safety instructions are not covered by the product liability regulations.
1.2

Symbols

Important safety instructions. Failure to comply with instructions could result in
personal injury or property damage.
Important information.
1.3

Intended Use

This equipment is to be used exclusively for the testing of shock absorbers and
suspension systems of motor vehicles. Observe the rated axle load.
The equipment shall not be modified without the express written consent of the
manufacturer. In case of non-compliance the declaration of conformity
becomes void.
Any use other than described is inappropriate.
1.4

Safety Instructions

 The tester may not be installed in hazardous locations or moist rooms such
as a car wash.
 The tester may only be used for its intended purpose and within its stated
performance limits.
 The tester may only be operated by trained personnel.
 Keep the tester and the working area clean.
 The tester must be turned off when not in use.
 No persons are allowed in the danger zone of the tester. Plates in motion are
potentially dangerous!
 Running vehicle engines represent a potential danger of poisoning. The own-
er/operator is responsible for providing sufficient air ventilation.
 Service work may be done by authorized service technicians only.
 Work on the electrical equipment may be done by certified electricians only.
BA031701-en
3