Safety; Introduction; Safety Regulations For Commissioning - MAHA TPS I Operating Instructions Manual

1

Safety

1.1

Introduction

Please read the standard operating procedures and user's manual thoroughly and carefully
before commissioning the machinery and comply with the instructions. The operating manual
should always be conveniently stored to be readily available at all times.
This operating manual is an addition to the operating manual for the testing lane Eurosystem.
All safety instructions provided in chapter 1 of these operating instructions must be complied
with.
Injury to persons incurred due to non-compliance with these operating instructions are not
covered by the product liability regulations.
MAHA is not liable for damage to the test stand and/or vehicles incurred due to non-compliance
with these operating instructions.
A warning means that instructions that are not complied with or incompletely complied with can
endanger persons.
Attention means that instructions that are not complied with or incompletely complied with can
lead to equipment damage.
Notes provide additional information.
Safety information is provided to warn about dangerous situations and help prevent damage to
equipment and injury to persons. For your own safety it is imperative that all safety regulations
included in these instructions be carefully observed.
The operating manual for the speedometer tester must be read thoroughly and completely by
the operator before commissioning.
Carefully observe all federal and international safety guidelines for work place protection.
Every user is responsible for observing all regulations which apply to his workplace and is
obliged to integrate any new regulations that may be initiated.
1.2

Safety Regulations for Commissioning

 The speedometer tester may only be commissioned by MAHA Service technicians or those
authorized by MAHA as service partners.
 All electrical parts of the testing machinery must be protected from moisture and humidity.
 The speedometer tester may not be installed and operated in explosion endangered rooms
or wash halls.
D1 1004BA1-GB03
TPS I and III for Eurosystem
1