Basic Rack PDU User Manual Table of Contents Basic Rack PDUs Contacting Panduit Symbols Used Equipment Overview Model Numbering Format Part Numbering Format Pre-Installation Product Inspection Installation Before You Begin Hardwire PDU installation instructions Unterminated Cord PDU installation instructions Standard Accessories...
Basic Rack PDU User Manual Basic Rack PDUs Panduit Basic Rack PDUs provide reliable power distribution to devices installed within a cabinet. This equipment has been designed for connection to an IT power distribution system. Contacting Panduit For technical support on PDU hardware and associated software, please contact Pan-...
Basic Rack PDU User Manual Equipment Overview The power inlet/cord(s) connects the PDU to the electrical power source. The LCD dis- plays the current load for each input feed or electrical phase per input feed. For IEC C-20 inlet PDUs, a customer-supplied cord is used for connection to the power source. The connection end to the PDU has an IEC C-19 plug for connection to the...
Basic Rack PDU User Manual Part Numbering Format This section describes the part numbering format used to identify equipment in the PDU series. PDU devices are numbered using one of the following formats: H1M-ABCDEFGHJKLM V1M-ABCDEFGHJKLM The H1M prefix indicates that the model is intended for horizontal mounting.
Basic Rack PDU User Manual Pre-Installation The Rack PDU products covered by this guide are designed to be installed within EIA racks and cabinets. Use of this product in other applications is acceptable, but other pre- cautions may be required to allow for specific installations not covered by this guideline.
Basic Rack PDU User Manual Installation Before You Begin Before installing your PDU, refer to the following lists to ensure that you have all the items shipped with the unit as well as all other items required for proper installation.
Page 9
Basic Rack PDU User Manual 5. Ensure conductors have enough slack (none should be under tension). 6. Feed grommet cap down cord and secure to input gland. Reference the table below to ensure the grommet cap is torqued correctly. Gland Size Grommet Cap Torque 1.5 N-m (13 in-lb.)
Basic Rack PDU User Manual Unterminated Cord PDU installation instructions This product is intended to be hardwired by the customer must be installed by a qualified electrician AND adhere to all national & local electrical codes. To install, match the corresponding conductor color to the matching phase in your facil- ity.