Connecting To The Side Battery Terminal - Intermec CK61 Installation Instructions Manual

Brown wire
Vehicle battery
(gray) cable
Red wire Fuse link
splice

Connecting to the Side Battery Terminal

It is very important to make sure that you make the
correct cable to battery connections, because
electrical energy from vehicle batteries can harm
equipment and people.
1 Remove both battery terminal side post bolts from the vehicle
battery.
2 Screw a 3/8" nut as far as it will go onto a 3/8" x 1 1/2" post
furnished in kit.
3 Slip a 3/8" washer onto the battery terminal post.
4 Slide the positive (red wire) fuse link terminal ring from the
battery cable onto the positive (+) battery terminal post.
5 Slip a second 3/8" washer onto the battery terminal post.
6 Slide the vehicle positive battery cable onto the battery
terminal post.
7 Thread the post assembly (Steps 2-6) into the positive battery
terminal. Tighten the battery terminal post securely.
8 Tighten the nut installed in Step 2 to secure washers and
cables firmly in place.
Vehicle Dock Kit Installation Instructions
Crimp here
Fuse link assembly
(P/N 236-107-001)
Terminal rings
9