Fastening The Ground Strap - Intermec CK61 Installation Instructions Manual

Repeat Steps 3 through 6 for the negative (brown) wire from the
battery cable, connecting the wire to the negative (-) battery
terminal.
Washers
Nut (2)
Red wire (positive)
Gray power cable

Fastening the Ground Strap

The white connector on the battery power cable has a braided
green wire grounding strap that you must fasten to the vehicle's
sheet metal to ensure proper cable shielding.
To fasten this ground strap
1 Drill a small hole into the metal where you intend to fasten
the ground strap.
2 Use a punch to dimple and enlarge the hole. Make sure the
hole is the same size as the screw.
3 Scrape a small circle of paint from around the hole. Make sure
to expose bare metal to make a good electrical connection.
4 Use a #8 x 5/8" screw and flat washer to secure the green
grounding strap.
Vehicle Dock Kit Installation Instructions
Positive battery terminal
Positive battery cable
5/16" x 1-1/2" post
Fuse link
Brown wire (negative)
Battery
11