Table of Contents
Advertisement
4.4 Model Removal
1.
Print the completed model as shown in the figure
1.
Use the spatula to press firmly against the platform
and gently from the corners
2.
Insert the spatula into the bottom of the model and
cock the spatula
Step 1
Step 3
1.
If the model is large, you can soak water around it
1.
If the model is too large to shovel down on one side
2.
Start over from the other three corners until the
model is shoveled down
— 25 —
Print More Materials, All For Application
Step 2
Step 4
Advertisement
Table of Contents
