Table of Contents
Advertisement
10. The print quality of the overhanging part is too
poor
11. Layer to layer misalignment
12. Filament Stringing
13. Weak filling
14. Printer monitor cannot be controlled cause
2. Increase the support density
3. There should be a certain gap between the support
and the model in the vertical direction, too large will
affect the surface quality of the support after removal,
too small will make it difficult to remove the support.
1. printing speed is too fast; you can properly reduce
the speed.
2. mechanical or electronic problems.
(1) mechanical: belt or top wire is loose, need to do
regular maintenance checks on the machine.
(2) electronic: possible motor or motor line
problems.
1. An appropriate increase in the length of the
pumping back and pumping back speed parameters.
2. When printing, the printhead moves back and
forth in the process, because the printhead is in a
heated state, the glue wire will still continue to melt
out. Appropriately reduce temperature of the nozzle,
can slow down the flow of supplies after melting.
1. The possibility of changing different filling patterns
to make the model more robust.
2. The printing speed can be reduced appropriately
3. The amount of filled out glue can be increased
appropriately
1. The problem of the cable. Platoon line as far as
possible to insert the bottom of the slot, do not tilt
poor. The display and the motherboard of the cable
slot of the clasp card good.
2, SD problems, ① the use of SD memory can not
exceed 8G ② TF card is not allowed to access the
card holder, as a standard SD use
— 42 —
Print More Materials, All For Application
Advertisement
Table of Contents
