4.4 Model Removal
1.
Print the completed model as shown in the figure
1.
Use the spatula to press firmly against the platform
and gently from the corners
2.
Insert the spatula into the bottom of the model and
cock the spatula
Step 1
Step 3
1.
Close the vacuum suction button and lift up the
outer end of the print base plate to slowly pull out
the base plate
1.
If the model is too large to shovel down on one side
2.
Start over from the other three corners until the
model is shoveled down
— 26 —
Print More Materials, All For Application
Step 2
Step 4