Set The Working Parameters - xtemp UXP 8011-HC090 Operating Instructions Manual

Chapter 3 Controller Descriptions and Operation
6
+
7
+
8
9

3.2 Set the working parameters

1) Set the working temperature
Refer to item No.2 in the table.
2) Set high temperature limit value
Press for more than 2 seconds until Ht is displayed. Press
Ht value is displayed, and press
and exit the SEt screen or exit automatically in 4 seconds.
3) Set low temperature limit value
Press for more than 2 seconds until Ht is displayed. Scroll the menu by
displays Lt . Press
XTEMP ENVIRONMENTS (SHANGHAI) CO., LTD.
http://www.xtemp-usa.com/
Initiate or
Press
terminate
at the same time
programming
and release the
buttons
Initiate or Press
terminate the
timer
the same time, then
release the buttons
Move between Press the key shortly
settings or for slow movement
increase the and continuously for
value fast changing
Move between Press the key shortly
settings or for slow movement
decrease the and continuously for
value fast changing
to enter Lt setting. Original Lt value is displayed, press
The temperature program may be initiated
and
either in standby mode or running mode. If
Auto
automatically resume to the mode before
the program is initiated once the program is
terminated automatically. The setting of
Auto
operation is desired after unexpected
interruption of short power failure.
The timer function is optional. When the
equipment is in running mode, timer for
and at
valid, while the equipment is in standby mode,
timer for
ASd
to get the desired value. Press
/
31 DSGO0708-2-V211119/UXP8011-CD6400/CLASS I/NFL/RT+5~+100°C
21
setting is , the equipment will
Aon
= is recommended, if continuous
Aon
is valid. The time is set by
AS
.
to enter Ht setting. Original
3
is
ASd
and
AS
to confirm
until screen
to