Table of Contents
Advertisement
Chapter 3 Controller Descriptions and Operation
3
4
5
+
XTEMP ENVIRONMENTS (SHANGHAI) CO., LTD.
http://www.xtemp-usa.com/
Display the
Press the button for
parameters of
less than 1 second
temperature
programming
Set the working
Press and hold the
parameters
key for more than 2
seconds
Set the
Press
programming
parameters
time then release
the buttons
When the programming is in progress, it
displays the segment number, temperature,
remaining time and cycles of active
program. The parameters are cycled and
displayed for 2 times with each delay of
about 2 seconds, and then exit
automatically.
is first displayed, press
Ht
,
cooL
Auto
Press
setting of the working parameter, for example
. Change the digits or setting by pressing
Ht
, or confirm and exit automatically in 4
seconds.
1)
The function is optional. The parameter
and
of first segment t1 is displayed. Press
at the same
display original time, press
new value, confirm the setting by pressing
to display temperature of the first
segment M1; Press
temperature, press
value, confirm the setting by pressing
enter the setting of second segment.
2)
Following the steps as for the first
segment for segments 2, 3 ... to 6 maximum. If
segments of less than 6 are desired, for
example only 2 segments are necessary, use
00:00 for t3 after confirmation of M2.
3)
Press
number of program circles.1～99 means 1
cycle to 99 circles maximum and 0 means
unlimited circles. Press
exist.
4)
Default parameters: t= 00:00, M=25, n=99
/
31
DSGO0708-2-V211119/UXP8011-CD6400/CLASS I/NFL/RT+5~+100°C
20
,
,
,
,
Atc
AS
ASd
cF
to enter for change of a definite
, accept the setting by pressing
to display the original
to display n, which means the
to confirm and
3
for
,
Lt
,
,
dEFt
ESc
to
for a
for a new
to
Advertisement
Table of Contents
