Working Status Indicating; The Key Functions And Navigate The Menu - xtemp UXP 8011-HC090 Operating Instructions Manual

Chapter 3 Controller Descriptions and Operation

3.1.2 Working status indicating

Heater: Press
steadily lit with full power heating; When LED flashes, the heating power is automatically
adjusted to meet actual need. LED flashing frequency keeps constant when temperature is
stabilized.
Compressor: Not applicable for this series of equipment.
Circulating pump: Press
on, after which the heating operation is possible.
Alarm: Red LED is on, when there is beeping and warning for safety or error is triggered.
The warning or error of the sensor may be accompanied by the following:
Ht ：When temperature in the bath is higher than the set value, Ht is displayed
Lt ：When temperature in the bath is lower than the set value, Lt is displayed
Er01 : Warning of temperature sensor short-circuit.
Er02 : Warning of temperature sensor open-circuit.
ourh : Warning of the bath temperature far beyond Ht .
Stb : The independent safety temperature limiter (STB) is triggered; Press
and to reset.

3.1.3 The key functions and navigate the menu

There're 6 keys as follows. The function and their operation are summarized and listed in the table:
KEY NO
1
2
XTEMP ENVIRONMENTS (SHANGHAI) CO., LTD.
http://www.xtemp-usa.com/
for more than 2 seconds to initiate the circulating pump. Orange LED will be
for more than 2 seconds to initiate the circulating pump with LED
FUNCTION
Initiate or Press and hold the
terminate the key for more than 2
temperature seconds
control
Set the working Press the button for
temperature less than 1 second
OPERATION
Temperature regulating is possible only if the
circulating pump is activated and
temperature control is initiated.
SEt is first displayed, then press
change the digits by pressing
accept the setting by pressing
/
31 DSGO0708-2-V211119/UXP8011-CD6400/CLASS I/NFL/RT+5~+100°C
19
3
(Fig 6-60)
REMARKS
to enter,
.
,