Adjusting Screens; Digital Signal Input; Analog Signal Input - Eizo RadiForce MX191 Installation Manual

2-4. Adjusting Screens

●

Digital Signal Input

When digital signals are input, images are displayed correctly based on the preset data of the
monitor, but if you perform more advanced adjustment, see
subsequent pages.
●

Analog Signal Input

Attention
• It takes about 30 minutes for the performance of electrical parts to stabilize. Please wait 30 minutes or more
after the monitor power has been turned on or the monitor has recovered from the power saving mode, and
then adjust the monitor.
• The Self Adjust (automatic screen adjustment) function does not work for the images under the resolution of
800 × 600 (SVGA).
• The self adjustment and auto adjustment functions work correctly when an image is fully displayed over the
Windows or Macintosh display area. They do not work properly in the cases below:
- when an image is displayed only on a part of the screen (command prompt window, for example)
- when a black background (wallpaper, etc.) is in use
Also, these functions cannot work properly in some graphic boards.
The monitor screen adjustment is used to suppress flickering of the screen or adjust screen position
and screen.
Note
• The self adjustment function works when all of the following conditions are satisfied:
- When a signal is input into the monitor for the first time or when a resolution or vertical/horizontal scan
frequency not used before is set.
If the screen is not displayed correctly even after performing the self adjustment operation, adjust the
screen according to the procedures on the following pages to use the monitor comfortably.
How to Set
1.
Perform the auto adjustment.
●
To adjust flickering, screen position, and screen size automatically
Procedure
1. Press .
The adjustment menu appears.
2. Select (Analog).
3. Select (AutoSize).
Flickering, screen position, and screen size are adjusted automatically.
4. After confirming the screen message, select
If you select
If the screen is not displayed correctly even after performing Auto Adjustment, perform the adjustments
according to the procedures on the following pages. If the screen is displayed correctly, go to
color gradation." (page
(Undo), the monitor returns to the pre-adjusted status.
16).
""2-3. Adjusting Color" (page
(OK).
Chapter 2 Adjusting Screens
8)" and
"5. Adjusting
13