Setting Up Projector A - InFocus IN5122 Manual

Setting up Projector A

1.
Turn on Projector A.
2.
Use the VERTICAL adjuster to set the lens to its upper-most position.
NOTES • If the lens is not at its upper-most position, Projector B's image
may not superimpose well onto Projector A's image.
• Choose CEILING and REAR settings first as needed as it may change the
image position.
• Set the HORIZONTAL adjuster near its center position.
3.
Adjust the Projector A image to fit the screen using the VERTICAL and
HORIZONTAL adjusters, and the ZOOM and FOCUS rings.
→
Guide Displaying the
Adjust the image position using KEYSTONE and CORNER CORRECTION as
needed. (User's Manual
• Do not adjust the ZOOM ring to its widest position, otherwise
NOTES
Projector B's image may not superimpose well onto Projector A's image.
Adjusting Projector B's image position electronically does not increase its
image size. Use the ZOOM ring to adjust Projector B's image size slightly
larger than Projector A's.
• KEYSTONE cannot be operated when CORNER CORRECTION is in use.
To adjust the image using both KEYSTONE and CORNER CORRECTION,
adjust KEYSTONE first.
• If you are using a Simple Stack, go to
B). ( 11 )
(Projector
4.
Display the menu with the MENU button.
menu function)
5.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
The STACK menu will appear on screen.
(User's Manual
(continued on next page)
(User's Manual
picture)
→
BASIC MENU
→
OPTION menu)
→ SETUP menu)
or
SETUP
2.3 Installation of the second projector
(User's Manual
9
Installation
(Quick Start
menu)
→ Using the