Connecting An External Speaker; Powering Up The Projector And Adjusting The Image - InFocus LP 730 User Manual

Connecting an External Speaker

To connect one or two external speakers, plug the speaker cable
into the (audio out) connector on the projector.

Powering up the Projector and Adjusting the Image

1 Remove the lens cap.
2 Plug the power cord into the front of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended if power surges are common in your area.
3 Turn on the projector by pressing the "I" side of the power
switch on the front of the projector.
The In Focus startup screen displays and the Power LED
•
lights (Figure 25 on page 27).
4 If you connected a video player, turn it on.
Press the
•
video
from your video player. (You can select a default source to
determine which source the projector examines first during
power-up for active video; see "Default Source" on
page 38.)
Use the
•
volume
button on the keypad to display the image
buttons to adjust the volume.
F
IGURE
Connecting an external speaker
NOTE: The external speakers
must be amplified.
20
NOTE: Always use the power cord
that shipped with the projector.
CAUTION: If the lamp LED
remains solidly lit after the projec-
tor has powered on, the lamp
needs to be replaced. Refer to
"Replacing the Projection Lamp"
on page 41 for more information.
21