Otto Bock Start M1 Instructions For Use Manual page 13

CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of qualified personnel.
► After every assembly, check for proper mounting of the drive wheels. The quick-release axles must be
securely locked in the receiver bushings.
► Pay particular attention to the stability against tipping, free running of the drive wheels and correct function of
the brakes/wheel locks.
INFORMATION
On the topic of disassembly/transport: see Page 27.
It only takes a few simple steps to prepare the wheelchair for use:
1) Attach the drive wheels to the receiver bushings (see fig. 2):
→ Press the button on the quick-release axle.
→ Attach the drive wheel to the receiver bushing and release the button on the quick-release axle.
→ The quick-release axles must not be removable after releasing the push-button.
2) Unfold the wheelchair (see fig. 3).
3) Attach the leg supports (see Page 14).
4) If necessary: Pull the part of the flap that can be fastened forwards and fasten tightly to the seat upholstery
(see fig. 4).
5) If necessary: Fit the seat cushion. The seat cushion is secured against sliding by being pressed on to the
hook-and-loop fastener ().
2
4
Start M1
3
Preparation for use
13