Adjustment Of The Anti-Kickback Fingers; Figure 57: Rubber Roller Replacement Step 5A; Figure 58: Rubber Roller Replacement Step 5B; Figure 59: Adjusting Screws - HOKUBEMA PANHANS 436/100 Operating Manual

Step 5
Place the sleeve and the shim washer and push them in. Important: The black sealing ring must be fitted
properly. Use a press-in tube or a piece of wood and a rubber mallet to carefully tap the pendulum bearing
inwards. Then tighten with the M8 screw (SW 13) and washer.

Figure 57: Rubber roller replacement Step 5a

The outfeed rollers are then also replaced in the same way.

15.6 Adjustment of the Anti-Kickback Fingers

Figure 59: Adjusting screws

• Loosen the three M6 adjusting screws (E) in the
oblong holes with an SW10 spanner, push them
all the way up and lightly tack them in place.
•
Measure the actual height of the squared timber and set 2 mm more on the thickness planer.
Example: Height squared timber = 200 mm | Setting thickness planer = 202 mm
• Loosen the tacked adjustment screws (E) and make sure that all fingers rest on the squared timber.
• Now push the three adjusting screws (E) all the way down and tighten them again.
• The procedure is completed.
BA_PH_436-100_EN_44-21.docx

Figure 58: Rubber roller replacement Step 5b

Figure 60: Dressed squared timber as adjusting aid

• Dress a square timber (K) with a length of approx.
620 mm and a height of at least 150 mm. This
serves as an adjustment aid.
46