Commissioning; Switching The Machine On And Off; Switch On; Switch Off - HOKUBEMA PANHANS 436/100 Operating Manual

9

Commissioning

Read the operating manual and the chapter  4 "Safety" carefully before commissioning and observe them.
Before switching on, check that
• there are no loose parts on the thicknessing table and that all tools have been removed,
• the guards are fitted in accordance with regulations,
• the extraction system is connected and in working order,
• the direction of rotation is correct,
• the V-belts are perfectly tensioned
• and no persons are in a danger zone of the machine
9.1

Switching the Machine ON and OFF

9.1.1 Switch ON

• Turn the main switch (1) on the rear of the machine (see  Figure 11) to position "I".

The machine can only be started when the switch (8) for the feed drive is in position "0"
and the switch (10) "Brake Release" is set to "Normal Mode" (right)!
• Start the cutter head with the push button (7).
• Set the desired feed rate:
a) Two step feed (standard):
Turn the Selector switch (8) to position I (= 7 m/min)
or to position II (= 14 m/min) → The feed runs.
b) Variable feed (option):
Turn the potentiometer (9) completely to the left
and switch on the feed with the push-button (8).
Then set the desired feed rate (3 ... 24 m/min) by
turning the potentiometer (9). The current speed
rate is displayed on the screen of the position con-
trol unit (see chapter  10).
Important: Do not start working until the machine has reached full speed (after approx. 10 s), as the feed
drive can only be started afterwards (see warnings in the section  10.7.1).
• The height is adjusted via the position controller (3). Procedure see section  10.4.

9.1.2 Switch OFF

• Switch off the feed switch (8).
• Stop the cutter head with push button (7).
• Switch off the main switch (1) on the rear.

9.1.3 Emergency Stop System

In case of an emergency, the machine can be shut down via the following two switches:
1. Emergency stop button (5) on the control panel on the infeed side.
2. Main switch (1) on the rear of the machine.
BA_PH_436-100_EN_44-21.docx
9
0 II
8
7
5

Figure 14: Control panels (standard and option)

Optional
. .
3
2 4
. .
1 . . 5
0
10
28