Special Work Within The Scope Of Maintenance Work As Well As Troubleshooting In The Workflow; Safe Working Practices - HOKUBEMA PANHANS 436/100 Operating Manual

4.3.2 Special work within the Scope of Maintenance Work as well as Troubleshooting in
the Workflow
Observe maintenance and inspection activities prescribed in the operating manual!
These activities, as well as all other repair work, may only be carried out by qualified personnel!
For all work concerning operation, production adjustment, conversion or setting of the machine and its
safety-related equipment as well as maintenance and repair, observe switch-on and switch-off procedures
according to the operating manual and instructions for maintenance work!
Secure the machine against unexpected restarting during maintenance and repair work.
➔ Lock the main switch with a padlock!
Always tighten screw connections that have been loosened during maintenance and repair work!
If it is necessary to dismantle safety equipment during set-up, maintenance and repair, the safety equip-
ment must be reassembled and checked immediately after completion of the maintenance and repair
work!
Ensure safe and environmentally friendly disposal of operating and auxiliary materials (e.g. oils) and re-
placement parts (e.g. electronic components)!

4.3.3 Safe Working Practices

Always work with all protective devices! These must be in the intended places and in perfect working or-
der. Defective guards must be replaced immediately.
Do not start planing until the motor / tool has reached full speed.
Do not use damaged tools resp. knifes or cutting blocks.
Damaged parts must be replaced with new ones.
Do not exceed the permissible speed of the tool.
Workpieces that are longer than the infeed or outfeed table must be supported additionally
(e.g. table extension, support rollers or similar).
Danger from ejecting parts! Always keep the insertion shaft clear when the cutter is running and do not
look into the opening.
Repairs may only be carried out by qualified personnel and with the main switch locked.
The machine is equipped with a mechanical brake. If this brake no longer brakes within the prescribed
braking time (10 s) despite readjustment, the customer service of the manufacturer must be contacted.
BA_PH_436-100_EN_44-21.docx
16