Operation With Position Controller; Buttons And Symbols; Figure 15: Touchscreen Position Controller - HOKUBEMA PANHANS 436/100 Operating Manual

10 Operation with Position Controller

Before adjusting the table, make sure that there are no objects on it that could be trapped!

Figure 15: Touchscreen position controller

10.1 Buttons and Symbols

Depending on the active mode, different symbols and buttons appear on the screen of the control unit.
The respective functions are described in the following table:
Action Function
Back to the main menu.
Starts the positioning process to the specified setpoint.
Stop Stops a running positioning process.
Kette Switch to incremental mode.
Abs Switch back to absolute mode.
Starts the calibration of the table height in the setup mode.
Set
After entering the calibration value, the "Set" button turns red. This is to indicate that the
key must now be pressed. As soon as the calibration value has been adopted, the button
Set
changes back to the grey background.
Symbol opens the "Info" menu with relevant additional information, e.g. operating status
i
of the machine, such as emergency stop, motor protection and motor voltages.
If the symbol described above appears in red, an error is detected (e.g. the machine is in
i
the end limit zone). Work can only be continued after the error has been remedied.
Language selection in the "Info" menu (currently available: German, English and French).
BA_PH_436-100_EN_44-21.docx
The touchscreen position controller serves the
following purposes:
•
Height adjustment of the thicknessing table
•
Calibrating the thicknessing table height
(password protected)
•
Display of the machine's operating status (emer-
gency stop, motor protection, motor voltages)
•
Display of status and error messages
•
For indicating the feed rate
(only with variable feed rate option)
•
Setting machine parameters (for authorised per-
sonnel only, see separate  Service Manual)
29