Table of Contents
Advertisement
15.2 Lubrication Instructions
The machine was subjected to a longer test run at the
factory and has already been lubricated ready for opera-
tion. Relubrication before commissioning is therefore
not necessary. Lubricate the machine only with special
grease, e.g.
• PANHANS ZET-GE M 50
• ARCANOL BN 102
• CALIPSOL H442B
• Shell Gadus S2 V100 3 (formerly SHELL Alvania 3)
For oil lubrication we recommend:
•
Engine oil 20 W 40
Always use the same grease/oil and the supplied grease gun!
Switch off the machine during maintenance and repair work and secure it against being
switched on again unexpectedly! Lock the main switch with a padlock!
• Check all sliding or rolling parts weekly for smooth running and lu-
bricate with a thin oil if necessary.
• Apply a few drops of oil weekly to the threads of the clamping and
adjustment levers.
• Lubricate feed chain every 6 months with a suitable grease.
• Move the thicknessing table upwards every month and lubricate
the 4 adjusting spindles (N) with 2 grease shots each ( Figure 49).
• Lightly grease the two lateral guides (F) on the thicknessing table
(front and back) every month (Figure 50).
15.3 Replace / Tension the V-belt
Switch off the machine during maintenance and repair work and secure it against being
switched on again unexpectedly! Lock the main switch with a padlock!
•
Turn the main switch (1) to position "0"and lock it.
•
Remove the cover plate on the left side of the machine base.
15.3.1 Tension the Belt
•
See Figure 51: Loosen the two hexagon nuts (S) and push
the motor downwards with a wooden lever (H). Then tighten
the two nuts (S) again.
•
Do not tension the V-belt too tightly. It is correctly tensioned
when it can be pressed through between the V-belt pulleys by
about 1 cm with a lateral force of approx. 2 kg.
•
Finally, mount the cover plate again.
15.3.2 Replace the Belt
•
Loosen the two hexagon nuts (S) The motor can now be lifted
up to remove the V-belts.
•
Fit new V-belts and proceed as described in 15.3.1.
BA_PH_436-100_EN_44-21.docx
N
Figure 49: Grease nipples for adjusting spindles
Figure 50: Grease lateral guides
Figure 51: Tension the V-belt
N
H
S
43
Advertisement
Table of Contents
Troubleshooting
