Table of Contents
Advertisement
10.5 Calibrating the Table Height ("Setup" Menu)
The position controller makes it easy to calibrate the height of the thicknessing table.
For this purpose, you must first switch from normal positioning mode to the setup menu.
• Press the "Home" button to switch to the main menu.
• Then press the "Setup" button to enter the setup menu:
→ An alphanumeric keyboard appears with a password request.
7550
Enter the password
→ If the password has been entered correctly, the button "Calibrate" appears on the screen.
• Now press the "Calibrate" button to enter the calibration menu:
→ The calibration screen appears (see Figure 24)
Figure 24: Calibrate table height
• Now use a test workpiece that has already been dressed and set the table to any height that is suitable for a
thickness planing test run with the selected test workpiece.
• Start the thickness planing test run.
• Measure the machined test workpiece with a suitable measuring device (vernier caliper recommended!)
• Enter the measured value (z. B. 101.3 mm) into the "Cal. Value" field (see Figure 25):
→ The "Set" button in the bottom line of the screen is highlighted in red.
• Then press the "Set" button:
→ The table is automatically calibrated to the reference dimension
• Finally, press "Home" to return to the main menu.
10.6 Feed Rate Visualisation (Option)
Figure 26: Feed rate visualisation
BA_PH_436-100_EN_44-21.docx
and confirm with "ENT" (Enter).
On machines with infinitely variable feed (option, see
section 16.2), the current feed rate is visualised on
the left-hand side of the screen, as shown in the figure
on the left.
Note: This function is unavailable on machines with
two-stage standard feed.
Figure 25: Input of the reference value
32
Advertisement
Table of Contents
Troubleshooting
