Otto Bock 9X50 Instructions For Use Manual page 18

3) Apply sufficient silicone grease to the inside of the control element hous­
ing and the contact pins (see fig. 2).
4) Connect the plug connection between the housing and electrode cable
plug.
5) Push the plug on the electrode cable as deep as possible into the
product using a screwdriver (see fig. 3).
6) Remove any silicone grease that seeps out.
Electrode cable replacement
1) Pull off the electrode cable at right angles to the product (see fig. 4).
2) Cut off at least 5 mm of the electrode cable and push it back into the
plug connection.
7 Use
The 9X50 linear control element and the 9X51 4-stage control element are
attached between the shoulder harness and definitive socket (see fig. 5).
8 Legal information
8.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor­
ised modification of the product.
8.2 Trademarks
All product names mentioned in this document are subject without restriction
to the respective applicable trademark laws and are the property of the
respective owners.
All brands, trade names or company names may be registered trademarks
and are the property of the respective owners.
Should trademarks used in this document fail to be explicitly identified as
such, this does not justify the conclusion that the denotation in question is
free of third-party rights.
8.3 CE conformity
Otto Bock Healthcare Products GmbH hereby declares that the product is in
compliance with applicable European ergänzen!European requirements for
medical devices.
18