Memory Operation; General Description; Memory Channel Selection - Icom IC-R1500 Instruction Manual

■ General description

The receiver has 1100 memory channels including 100 scan
edge memory channels (50 pairs) for storage of often-used
frequencies. And a total of 21 memory banks, A to H, J to R,
T, U, W and Y are available for storing groups of frequencies,
etc. Up to 100 channels can be assigned into a bank.
D D Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency ((p. 9))
• Receive mode ((p. 10))
• Duplex direction (DUP+ or DUP–) with an offset fre-
quency ((p. 15))
• Tone squelch or DTCS squelch ON/OFF ((p. 33))
• Tone squelch frequency or DTCS code with polarity
((p. 38))
• Scan skip information ((p. 28))

MEMORY OPERATION

■ Memory channel selection

q Push [MR•SKIP] to select memory mode.
• "!" indicator appears.
[MR•SKIP]
w Rotate [DIAL] to select the desired memory channel.
• Programmed memory channels can only be selected.
If memory banks or weather channels* mode appears when
pushed [MR•SKIP] at step q, push [MR•SKIP] and rotate
[DIAL] to select "bAnk --," then push [MR• SKIP] again.
*Available for USA/CANADA versions only.
5
4
5
"!" appears
16