Table of Contents
Advertisement
13
HM-127 REMOTE-CONTROL MICROPHONE
I Set mode programming
Set mode is used to change the condition of the transceiver's
functions and the microphone's own functions:
Transceiver's functions—
scan mode (Normal or Priority), scan resume timer, weather
alert, Dualwatch/Tri-watch, DSC watch, transceiver's beep
tone, internal speaker (transceiver), LCD contrast (trans-
ceiver), RF attenuation level, scrambler code, scrambler type
and automatic acknowledgement.
Microphone's own functions—
beep tone function (microphone) and LCD contrast (micro-
phone).
In this section, instructions are for the microphone's own func-
tions only. Refer to pgs. 38–41 for the setting of the other
functions. (Some functions cannot be selected from the HM-
127.)
62
D D Entering Set mode
q Turn power OFF.
w While pushing
[
]
, turn power ON.
[
]
(
)
16
16
(
)
9
9
• After a beep emission, a Set mode item (in the channel comment in-
dicator and the condition in the channel number readout) is displayed.
e Push
[
]
to select the desired item, if necessary.
[
]
16
(
(
)
)
16
9
9
r Push
Y Y
Z Z
[
[
Y Y
] /
]
[
[
Z Z
] to select the desired condition of the item.
]
t Turn power OFF, then ON to exit Set mode.
• Beep tone "BEEP"
➥ Push
[
Y Y
] to turn ON,
[
Z Z
] to turn OFF the beep output.
[
Y Y
]
[
Z Z
]
Push
• LCD contrast "LCD CONTRAST"
➥ Push
Y Y
Z Z
[
[
Y Y
] /
]
[
[
Z Z
] to adjust to a suitable LCD contrast.
]
Push
Advertisement
Table of Contents
