Basic Operation; I Power On; I Setting A Frequency - Icom IC-T2H Instruction Manual

I Power ON

Rotate [PWR/VOL] clockwise
to turn power ON.
D Toggling frequency/channel
indication mode
Channel indication mode is used to simplify operation. In this
mode only pre-programmed memory channel numbers are
displayed and functions are limited ([PWR/VOL], [
[ ], [H/L] and [SC] are functional).
To toggle between the indication modes:
While pushing [Z] + [0], rotate [PWR/VOL] to turn power ON.
at power ON
Frequency indication
POWER ON
AT
L], [PTT],
D
0
Channel indication

BASIC OPERATION

I Setting a frequency

D Via the keypad
➀
Push [ V] to select VFO mode, if
A
necessary.
➁
Push 6 digit keys, starting from
the 100 MHz digit, to input a fre-
quency.
• Push the [M] key first to start input
from the 100 kHz digit, if desired.
• When a digit is mistakenly input,
push [ ] and input from the begin-
ning.
• "2" and "7" are acceptable for the 1
kHz digits (depending on the 10 kHz digit).
D Using the [Y]/[Z] keys
Each push increments/decrements the frequency according
to the selected tuning step (see right), except when the 100
kHz or 1 MHz dial select step is selected (see following
page). When a dial select step is selected, each push incre-
ments/decrements the frequency either 100 kHz or 1 MHz.
4
1 4 5
MR
5 0 0
MR
11