I Subaudible Tones; I Offset Frequency - Icom IC-T2H Instruction Manual

5
REPEATER OPERATION

I Subaudible tones

Some repeaters require subaudible tones to be accessed.
Subaudible tones are superimposed over your normal signal
and must be set in advance.
➀
Push [ V] for 1 sec. to enter set mode.
A
➁
Push [t] one or more times until
"RP" appears.
➂
Push [Y]/[Z] to select the desired
subaudible tone.
➃
Push [ V] to enter the selected
A
tone and exit set mode.
When set mode is selected from memory mode:
➄
Push [ M].
B
➅
Push [ V].
A
➆
Push [ M] for 1 sec.
B
Available subaudible tone frequencies
67.0 79.7 94.8 110.9 131.8 156.7 171.3 186.2 203.5 229.1
69.3 82.5 97.4 114.8 136.5 159.8 173.8 189.9 206.5 233.6
71.9 85.4 100.0 118.8 141.3 162.2 177.3 192.8 210.7 241.8
74.4 88.5 103.5 123.0 146.2 165.5 179.9 196.6 218.1 250.3
77.0 91.5 107.2 127.3 151.4 167.9 183.5 199.5 225.7 254.1
16

I Offset frequency

SET MODE
USING
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
➀
➁
T
➂
Subaudible tone of
88.5 Hz is selected.
➃
When set mode is selected from memory mode:
➄
➅
➆
(unit: Hz)
Push [ V] for 1 sec. to enter set mode.
A
Push [t] one or more times until
"oW" appears.
Push [Y]/[Z] to select the desired
offset frequency.
• Selectable steps are the same as the
pre-set tuning steps.
Push [ V] to enter the selected offset frequency and exit
A
set mode.
Push [ M].
B
Push [ V].
A
Push [ M] for 1 sec.
B
SET MODE
USING
DUP
Offset frequency of
0.60 MHz is selected.