Auto Repeater Function - Icom IC-Q7A Instruction Manual

Auto repeater function

(U.S.A. version only)
The U.S.A. version automatically activates the repeater set-
tings (duplex ON/OFF, duplex direction, tone encoder
ON/OFF) when the operating frequency falls within or outside
of the general repeater output frequency range. The offset
and repeater tone frequencies are not changed by the auto
repeater function, reset these frequencies, if necessary.
q Select VFO mode with [V/M].
w Push [V/M] for 2 sec. to enter expanded set mode.
e Rotate [DIAL] until "AUTO RP" appears.
• Turn the expanded set mode ON for selection. (p. 28)
• "AUTO RP" disappears after 1 sec. and "AR" appears.
r While pushing [FUNC], rotate [DIAL] to turn the auto re-
peater function ON (DUP ONLY or DUP TONE) or OFF.
t Push [V/M] to exit set mode.
DUP
Auto repeater function Activates for duplex
is turned OFF. only.
D Frequency range and offset direction
DUP
Activates for duplex
and tone.
REPEATER OPERATION
FREQUENCY RANGE
145.200–145.495 MHz
146.610–146.995 MHz
147.000–147.395 MHz
442.000–444.995 MHz
447.000–449.995 MHz
8
DUPLEX DIRECTION
"–DUP" appears
"DUP" appears
"DUP" appears
"–DUP" appears
25