Accessory Attachment - Icom IC-Q7A Instruction Manual

D Antenna
CAUTION:
Transmitting without an
antenna may damage the transceiver.
Insert the supplied antenna into the an-
tenna connector and screw down the an-
tenna as shown at right.
Keep the jack cover attached when jack
is not in use to avoid bad contacts from
dust and moisture.
D Battery installation
q Remove
the battery
cover from the trans-
ceiver.
w Install 2 R6 (AA) size al-
kaline, dry cell or op-
tional Ni-Cd batteries.
• Be sure to observe the cor-
rect polarity.
Keep battery contacts clean. It's a good idea to clean bat-
tery terminals once a week.

ACCESSORY ATTACHMENT

D Belt clip
Conveniently attaches to
your belt.
Slide the belt clip into the
plastic loop on the back of
the transceiver.
D Handstrap
Slide the handstrap through the loop
on the side of the belt clip as illus-
trated at right. Facilitates carrying.
1
1