Figure 20 Remote Controller In Config Mode With Menu 2 Selected, User Setting The -Lat Position Limit - ferrotec Genius II Quick Start Manual

1.5 Configuring the Control Modules
Figure 20 Remote Controller in Config Mode with Menu 2 Selected, User Setting the -Lat
Genius II Quick Start Guide
Position Limit
10 Use the joystick to move the beam to the position desired for the
+Latitude beam position limit.
11 When the beam is at the position desired for the +latitude limit, press
the Set +Lat button.
12 Use the joystick to move the beam to the position desired for the
+Longitude beam position limit.
13 When the beam is at the position desired for the +longitude limit,
press the Set +Long button.
14 Use the joystick to move the beam to the position desired for the
–Longitude beam position limit.
18
1.5.4 Configuring the Sweep Control Module
Press to set -Lateral position limit
0101-9031-0, Rev. B