Figure 19 Remote Controller, Beam On @ 5%, Config Mode, Menu 1 And Pos Adjust Selected - ferrotec Genius II Quick Start Manual

1.5.4 Configuring the Sweep Control Module

Figure 19 Remote Controller, Beam On @ 5%, Config Mode, Menu 1 and Pos Adjust Selected

0101-9031-0, Rev. B
7 Watching the beam through the viewport, use the remote controller's
joystick to move the beam to the desired position for the –Latitude
beam position interlock limit.
8 Press the remote controller's Menu button to select Menu 2, which is
shown in Figure 20.
9 With Menu 2 displayed, press the Set –Lat button to set the –Latitude
beam position limit at this position. The screen will then appear as
shown in Figure 20, with a white dashed line indicating the limit you
have just set.
17
1.5 Configuring the Control Modules
With Pos Adjust selected, use the
joystick to move the beam to the
desired position for the –Lateral
position limit.
Genius II Quick Start Guide