Table of Contents
Advertisement
1.5 Configuring the Control Modules
1.5 Configuring the Control Modules
1.5.1 Configuring All Module Control Modules for Remote Control
Genius II Quick Start Guide
2
Put the rear-panel On/Off switch in the On position.
3
Press the front-panel On/Off button (see Figure 1). The unit will then
boot up and display the Start screen (see Figure 9).
Step
Action
1
When the Genius II is first booted up, the main controller screen
displays the Start screen (see Figure 9). To put the unit into
Configuration Mode, touch this screen's Configuration button. The
unit will then display the Configuration>Main screen (see Figure 10).
Figure 9 Genius II Start Screen
Figure 10 Config>Main Screen After Initial Boot-Up
Note that Hardware Deactivated is displayed on the E-Beam, Sweep, and
Pocket buttons on the command button bar. This is because all three control
modules are factory-configured as Offline.
1.5.1 Configuring All Module Control Modules for Remote Control
10
0101-9031-0, Rev. B
Advertisement
Table of Contents
