Connecting The Ac Power Cable And Powering Up The Genius Ii; Figure 8 Genius Ii Input Power Cable Receptacle And Rear Panel On/Off Switch; Table 2 Functional Descriptions Of Pins On Rear Panel Connector X119 - ferrotec Genius II Quick Start Manual

1.3.3 Making Connections to a PLC-Based System Controller

Table 2 Functional Descriptions of Pins on Rear Panel Connector X119

Pin Functional Description
A1 Input 1: Data-set-selection Bit 1
A2 Input 2: Data-set-selection Bit 2
A3 Input 3: Data-set-selection Bit 3
A4 Input 4: Data-set-selection Bit 4
A5 Input 5: Data-set-selection Bit 5
A6 Input 6: Data-set-selection Bit 6
A7 COM IN; ground reference for inputs 1-6
A8 24 V, 1.5 A output; can be connected to Pin B5 to provide control voltage for outputs K1-K4.
B1 Output K1: Relay contact with B5; function = POCKET IN POSITION output.
B2 Output K2: Relay contact with B5; function = POS 0 (BCD bit 0)
B3 Output K3: Relay contact with B5; function = POS 1 (BCD bit 1)
B4 Output K4: Relay contact with B5; function = POS 2 (BCD bit 2)
B5 COM OUT: Function: Either 0 V reference for Outputs K1-K4, if jumpered to Pin B8, or 1.5-A control voltage for the
same outputs, if jumpered to Pin A8
B6 Output T1: Transistorized output not implemented on Genius II
B7 Output T2: Transistorized output not implemented on Genius II
B8 Internally connected to ground; can be connected to Pin B5 to provide 0 V reference for outputs K1-K4
1.4

Connecting the AC Power Cable and Powering Up the Genius II

Perform the following procedure to supply AC power to the Genius I.

Figure 8 Genius II Input Power Cable Receptacle and Rear Panel On/Off Switch

0101-9031-0, Rev. B
Step Action
1 Make sure that the rear-panel On/Off switch (see Figure 8) is in the
Off position.
1 Plug the unit's power cable into the rear-panel input power receptacle
and into an appropriate source of AC power.
9
1.4 Connecting the AC Power Cable and Powering Up the Genius II
On/Off Switch
Receptacle for
Input Power Cable
Genius II Quick Start Guide