Figure 11 Configuration>Main Screen After User Configures All Control Modules As Remote I/O; Figure 12 Configuration E-Beam Screen After Initial Boot-Up - ferrotec Genius II Quick Start Manual

1.5.2 Configuring the EBeam Control Module
Figure 11 Configuration>Main Screen After User Configures All Control Modules as Remote I/O
1.5.2 Configuring the EBeam Control Module

Figure 12 Configuration E-Beam Screen After Initial Boot-Up

0101-9031-0, Rev. B
Touch the buttons opposite Ebeam modules, Sweeper Module,
2
and Turret Module twice each to select Remote I/O for all three
control modules. The Config>Main screen will then appear as shown
in Figure 11
Step Action
Touch the Menu Bar's E-Beam button to display the Config>E-Beam
1
screen (see Figure 12).
2 Select the desired power supply, if it is not already selected. To do so,
touch the Carrera Type button to toggle between the four power
supply options.
3 Leave EXTERNAL selected opposite Emis Control.
4 If desired, you can change the default kV value. To do so:
a) Touch the kV Set button to display a numeric keypad.
b) Use that keypad to enter the desired default value.
c) Touch Enter to close the keypad. The value you entered will then
appear on the kV Set button.
11
1.5 Configuring the Control Modules
Genius II Quick Start Guide