Options While Measuring - Profound VIBRA Series Manual

Display of the during the measurement shown dominant frequency
using: 1 for [FFT (DIN) or Method I (SBR)] or
This display setting can be set in the sub measurement menu, as described in the next paragraph.
Independent of the chosen Frequency Type, both dominant frequency methods are automatically
applied and saved while measuring (VIBRA
In the PC software VIBRA +
Crossing.
5.2.2

Options while measuring

Press Stop to end measuring. While measuring you can press
measuring submenu:
•
VIBRA Info
•
Stop Measurement : end the measurement
•
Frequency
•
Clear Maxima
•
Test Alarm
•
Display Contrast
•
Send Email
Except for the option Stop Measurement, entering these options will not interrupt the measurement.
Ending the measurement or resetting a maximum (only the maximum shown) can also be done
directly in the measuring menu.
2 for [Zero Crossing (DIN) or Method II (SBR)]
+ only). A VIBRA always uses Zero Crossing.
-measurements can always be displayed according to FFT or Zero
: ID-data of the system as well as the geophone
: set the displayed frequency method
: reset all maximum values to zero
: check correct functioning of the external alarm beacon (see § 5.7)
: manually adjust the display contrast (see § 5.5)
: manually send an e-mail containing the peak data (except traces)
to the preset address in the PC software (see chapter 7)
Manual Profound VIBRA-series, version 2.00
Menu to enter the following
26