Fisher & Paykel DE8060P Installation Manual/User Manual page 40

PROBLEM
Cycle time longer
than usual.
Small amount of
water in the drum
at end of cycle.
Noises.
Vibration.
Creasing.
40
TROUBLESHOOTING
POSSIBLE CAUSES
Cycle time may be affected
by a number of factors and
is approximate.
Water tank needs to
be emptied.
Environmental conditions may
be affecting dryer operation.
Dryer is overloaded.
Dryer is experiencing a fault.
Beeps signalling the end of a
drying cycle.
Dryer is not installed on a
stable surface.
Dryer is not level.
Dryer is overloaded.
Cycle selection not
appropriate for the load.
Dryer is overloaded.
selected
DRYNESS LEVEL
too high for load type.
option
WRINKLE FREE
not selected.
Wet items left sitting in the
dryer for a long period before
starting the cycle.
WHAT TO DO
Cycle time is affected by the size
and composition of the load, how
wet/dry the load was to begin with,
the environmental conditions the
dryer is operating in, cycle options
selected, sensing while drying and any
interruptions during the cycle. Refer
to 'Sorting'.
Empty the water tank.
If conditions are particularly hot and
humid, it is possible vaporised water
may re-condense in the drum or on
the inside of the door.
Remove some items from the dryer.
Continuous beeping or a musical series
of beeps with a message displayed on
digital display. Refer to pages 'Before
you call for service' and 'Fault codes'.
End of cycle beeps can be turned off.
Refer to 'Drying options'.
Ensure the dryer is installed on a flat,
stable surface. Refer to 'Levelling
the Dryer'.
Ensure the dryer is correctly levelled.
Refer to 'Levelling the Dryer'.
Remove some items from the dryer.
Select the
EASY IRON
minimise creasing.
Remove some items from the dryer.
Try selecting a lower
Select the
WRINKLE FREE
rotate the load at the end of the
drying cycle. Refer to '
Try not to leave wet items sitting in
the dryer for long periods.
cycle to
.
DRYNESS LEVEL
option to
'.
WRINKLE FREE