Table of Contents
Advertisement
GREASE FITTINGS
There are twelve grease fittings on the HDII Rake. If lubricated properly and often enough, it will prolong
the life of your HDII Rake. Grease daily during normal use and before and after storage and after
power washing. Use a good grade of high quality grease. Make sure that grease comes out around the
shaft on
sleeve type bearings. Wipe off excessive grease to prevent accumulation of chaff or grit
around the bearing.
LOCATION
Listed and shown are the description of location and number of grease fittings.
A.
(4)
Two on each Lifting Cylinder Mount
B.
(2)
One on each Tandem Pin
C.
(4)
Two on each Beam Pivot (1) Top Pivot (1) Bottom Pivot
D.
(2)
Ratchet Jack
C
LUBRICATION GUIDE
D
-15-
A
B
Advertisement
Table of Contents
