H&S HDII RAKE Operator's Manual And Parts List page 14

NOTE: TRACTOR HYDRAULIC LEVER MUST BE ENGAGED TO PROVIDE OIL FLOW TO RAKE.
CENTER FRAME
When opening or closing the center frame of the
rake, it is necessary to have forward or rearward
motion to prevent any serious damage to rake.
Each side has it's own switch on the control box.
There is a convenient number system on the two
slider tubes to let the operator know where each
side is located.
B E
A
RAKING ANGLE/WINDROW WIDTH
The right and left rake wheel beam can be angled
separately by their own switch on the control box.
By angling each side more or less the desired
windrow width can be accomplished.
OPERATION
F D
G C
NUMBERS
CONTROL BOX
The control box allows the operator to make many
adjustments from the tractor seat. It is set up in
three basic areas. The left side has two switches,
one (A) for sliding the left center frame in or out,
the other switch (B) controls the rake wheel beam
angle. The right side also has two switches one(C)
for sliding the right center frame in or out, the
other switch (D) controls the rake wheel beam
angle. In the center of the control box there are
three switches. The switch on the left (E) will raise
and lower the the left side rake wheels. The switch
on the right (F) will raise and lower the right side
rake wheels. The switch in the center (G) will raise
and lower both left and right rake wheels.
-12-