Wiring The Outputs; Making The Speaker Binding Posts User Friendly; Figure 20-Sometimes The Input Connector Needs To Be Bent To Clear The Pcb - DYNACO STEREO 120 Updating Instructions

1. Solder the left channel black wire (ground) into the remaining INGND eyelet of
the left channel PCB.
2. Solder the left channel green (signal) wire into the IN eyelet of the left channel
PCB.
3. Solder the right channel black wire (ground) into the INGND eyelet of the right
channel PCB.
4. Solder the right channel green (signal) wire into the IN eyelet of the right channel
PCB.
On the left channel amplifier, it may be necessary to bend the terminal of the RCA phone
jack to avoid interference with the circuit board.

Figure 20-Sometimes the input connector needs to be bent to clear the PCB

Wiring the Outputs

You should be able to use the existing wires to connect the speaker binding posts to the
amplifier board.
1. Solder the wire from the left channel red binding post to the left channel PCB
OUT eyelet.
2. Solder the black wire from the left channel black binding post to the left channel
PCB OGND eyelet.
3. Solder the wire from the right channel red binding post to the right channel PCB
OUT eyelet.
4. Solder the black wire from the right channel black binding post to the right
channel PCB OGND eyelet.

Making the Speaker Binding Posts User Friendly

The speaker binding posts have holes for the speaker wire. These holes should be
oriented from side to side, not up and down, to allow easy connection of the speaker
Page 28 of 32