Table of Contents
Advertisement
Removing C7 RIGHT
1. Remove the 3 sets of #6 hardware that hold C7 RIGHT to the bottom of the
chassis.
2. Unroll one foot of the wire that's wrapped around C7 RIGHT and connects to the
RIGHT RED Binding post.
3. Cut this wire near C7 RIGHT so that about 1 foot of wire remains connected to
the RIGHT RED Binding post.
Removing C7 LEFT
4. Remove the 3 sets of #6 hardware that hold C7 LEFT to the bottom of the chassis.
5. Unroll one foot of the wire that's wrapped around C7 LEFT and connects to the
LEFT RED Binding post.
6. Cut this wire near C7 LEFT so that about 1 foot of wire remains connected to the
LEFT RED Binding post.
Removing the Output Zobel Networks
1. Clip the lead of the 0.1 uF capacitor that connects to the RIGHT RED binding
post, near the RIGHT RED Binding post.
2. Clip the lead of the 4.7 Ohm resistor that connects to the RIGHT BLACK binding
post, near the RIGHT BLACK binding post.
3. Clip the lead of the 0.1 uF capacitor that connects to the LEFT RED binding post,
near the LEFT RED Binding post.
4. Clip the lead of the 4.7 Ohm resistor that connects to the LEFT BLACK binding
post, near the LEFT BLACK binding post.
5. Remove the terminal strip and the two attached resistors and capacitors.
Figure 4 shows what the amplifier should look like when you've completed this step.
Page 11 of 32
Advertisement
Table of Contents
