Figure 8-Leads Soldered And Clipped - DYNACO STEREO 120 Updating Instructions

When you're done this section, there will only be two empty slots for resistors:
1. R16, a no-load, which will remain empty.
2. R15, a power resistor, which we will load later.
Keep track of your progress by placing a check-mark in the done column as every resistor
is installed. The resistor values can be checked with a meter, or by reading the color code.
Designation Value
R14 10
R19 10
R20 10
R21 10
R13 100
R1 100K
R2 100K
R3 100K
R5 100K
R7 100K
R8 100K
R4 1K
R6 1K
R9 1K
R10 1K
R18 1K
R11 20K
R12 20K
R17 2K87
R15 10 (1 Watt)
R16
Note: R8 and R18 are near each other on the board. Be careful...don't mix them up!

Figure 8-leads soldered and clipped

Color Code
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Black, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Red, Black, Black, Red, Brown
Red, Black, Black, Red, Brown
Red, Gray, Violet, Brown, Brown
Brown, Black, Black, Gold, Brown. This
resistor has a larger body than the others.
This Location Remains Empty
Page 17 of 32
Done?