Solder The Lm3886 Into The Board; Figure 12-Lm3886 Installation Step One, Just The Corner Pins Are Soldered; Figure 13-The Lm3886 Sits Up Off The Board To Avoid Shorts Between The Front And Back - DYNACO STEREO 120 Updating Instructions

Solder the LM3886 into the Board

This is the last step in stuffing the circuit board. By now, you are pretty good at soldering.
Your skill will help you with this step. Just follow the instructions calmly and carefully,
and you'll do just fine.
1. Insert the LM3886 in from the component side of the board. Once it's through the
board, you can bend to corner leads on the bottom side of the board to hold the
LM3886 in place. Solder just the corner pins (See Figure 12).
2. The LM3886 body should sit at right angles to the plane of the board.
3. The LM3886 body should sit up off the board to avoid short circuits between the
rows of pins (See Figure 13)

Figure 12-LM3886 installation step one, just the corner pins are soldered

Figure 13-The LM3886 sits up off the board to avoid shorts between the front and back rows of pins.
The body should be at right angles to the circuit board
Page 22 of 32