Figure 7-Leads Soldered And Clipped - DYNACO STEREO 120 Updating Instructions

When you're done this section, there will only be one empty resistor slot, R16, a no-load,
which will remain empty.
Track your progress by placing a check-mark in the done column as you install each
resistor. Check resistor values with a meter, or by reading the color code
resistor with the fat brown band on the right, then you can read both the Color Code
column and the resistor from left to right.
Designation Value
R14 10
R19 10
R20 10
R21 10
R13 100
R1 100K
R2 100K
R3 100K
R5 100K
R7 100K
R8 100K
R4 1K
R6 1K
R9 1K
R10 1K
R18 1K
R11 20K
R12 20K
R17 2K87
R15 10 (1 Watt)
R16
Note: R8 and R18 are near each other on the board. Be careful...don't mix them up!
1
See "Resistor Color Code" on page 32 to see how to read resistor color codes.

Figure 7-leads soldered and clipped

Color Code
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Gold, Brown
Brown, Black, Black, Black, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Orange, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Brown, Black, Black, Brown, Brown
Red, Black, Black, Red, Brown
Red, Black, Black, Red, Brown
Red, Gray, Violet, Brown, Brown
Brown, Black, Black, Gold, Brown. This
resistor body is larger than the others.
This Location Remains Empty
Page 16 of 32
1
. Orient the
Done?