Table of Contents
Advertisement
ADCP-80-552 • Issue 2 • November 2000
2 INSTALLATION
2.1 Hardware
Danger: To prevent electrical shock, never install equipment in a wet location or during a
lightning storm.
Caution: Electronic modules can be damaged by electrostatic discharge (ESD). Before
handling modules, wear an anti-static discharge wrist strap to prevent damage to electronic
components. Place modules in packing material when transporting or storing. When working
on modules, always place them on an approved anti-static mat that is electrically grounded.
Some chassis may be fully configured prior to shipment and can therefore be installed directly
into a rack when received. Otherwise, the chassis should be configured according to the
installation sections of the manual.
2.1.1
Chassis
Install chassis into rack as shown in
The DSXpert chassis can be mounted into a 19" rack (EIA 1.75" spacing and WECO 2.0"
spacing). Bracket attachments on the unit allow positioning from a flushed to an extended
mount. The chassis also can be mounted into a 23" rack (with 19"-to-23" extender brackets)
and 600mm rack (with 19"-to-600mm extender brackets).
Page 6
2000, ADC Telecommunications, Inc.
Figure
3.
Figure 3. Chassis Installation into Rack
14041-B
Advertisement
Table of Contents
