Table of Contents
Advertisement
Figure 11. To enable battery, set JP9 jumper across 2, 3.
To disable battery, set JP9 jumper across pins 1, 2.
2.1.5.3
DIP Switch Settings
Before installing the control card, the onboard DIP switches must be properly configured to
ensure proper operation of the DSXpert unit.
packages on the control card and their ON/OFF positions.
To set DIP switches:
1. Locate DIP switch packages labeled DS7, DS6, DS5, DS4, and DS3 on control card.
2. For each package, set switches according to the following DIP Switch
through 6. Refer to
The DIP switches on the DS3 package are used for TL1 applications. The TL1 command set
does not include commands for setting the amplifier, termination resistor, bridge resistor and
loopback features, and must therefore employ use of DIP switches. All other control
applications (for example, HP OpenView SNMP) can use commands from the ASCII
command set or MIB to enable or disable these features.
Figure 12
Figure 12
for ON/OFF positions of the DIP switches.
ADCP-80-552 • Issue 2 • November 2000
15968-A
shows the location of the DIP switch
© 2000, ADC Telecommunications, Inc.
Tables 2
Page 13
Advertisement
Table of Contents
