Table of Contents
Advertisement
ADCP-80-552 • Issue 2 • November 2000
To set DIP switches:
1. Locate DIP switch packages labeled DS7, DS6, DS5, DS4, and DS3 on control card.
2. For each package, set switches according to the following DIP switch tables 2 through 6.
Refer to figure 12 for ON/OFF positions of the DIP switches.
DS7 PACKAGE
1
2
On
Off
Off
5
6
Off
Off
Page 14
2000, ADC Telecommunications, Inc.
Figure 12. DIP Switch Packages on Control Card (ON and OFF positions shown)
Table 2. DIP Switch Positions, DS7 Package
3
4
Function
Enables ethernet port.
Disables ethernet port (default).
Factory use only (default).
Off
Not used (default).
Off
Not used (default).
7
8
Function
Not used (default).
Not used (default).
Off
Not used (default).
Off
Not used (default).
14042-B
Notes
Applicable to 8-bit CPU with ethernet
board. For 16-bit CPUs, this is ignored.
Set to Off.
Set to Off.
Set to Off.
Set to Off.
Notes
Set to Off.
Set to Off.
Set to Off.
Set to Off.
Advertisement
Table of Contents
