Table of Contents
Advertisement
Figure 9. Installation of Rear Test Equipment Card
2.1.5
Control Card
Caution: Electronic modules can be damaged by electrostatic discharge (ESD). Before
handling modules, wear an anti-static discharge wrist strap to prevent damage to electronic
components. Place modules in packing material when transporting or storing. When working
on modules, always place them on an approved anti-static mat that is electrically grounded.
Before installing the control card, the following procedures in this section must be performed:
1. Enable battery on control card via jumpers (section 2.1.5.2).
2. Configure DIP switches on control card (section 2.1.5.3).
2.1.5.1
Card Replacement
If required, remove the control card as shown in
modular chassis is hot-swappable and can be inserted and removed without powering down
the chassis.
ADCP-80-552 • Issue 2 • November 2000
Figure
10. The control card for the DSXpert
© 2000, ADC Telecommunications, Inc.
15966-A
Page 11
Advertisement
Table of Contents
