Table of Contents
Advertisement
ADCP-80-552 • Issue 2 • November 2000
Where n is the chassis number, oldpassword is the current password, newpassword is the new
password to be assigned. Enter NONE for no password.
For example, SET UNIT 1 TELNET PASSWORD NONE KAPPA123
Note: TELNET password must be assigned in order to assign MENU password.
TELNET password can be set to NONE (no password) only after MENU password is set
to NONE.
Step 5. Reset DSXpert unit. Enter the following command to reset the chassis and apply new
settings:
RESET UNIT n
Where n is the chassis number.
Step 6. Connect Ethernet Port (10baseT Port). Connect the ethernet port to the LAN as
shown in
Figure
provides remote access to the DSXpert unit via 10 baseT. The ethernet port is labeled 10bT.
Note: As of the date of this publication, only the 10baseT ethernet port on the front of
the control card is active. The 10baseT ethernet port on the rear of the chassis is reserved
for future implementation.
The pin assignments for the ethernet port are shown in
Page 30
2000, ADC Telecommunications, Inc.
23. The port is located on the front of the control card and chassis rear, and
14020-B
Figure 23. 10bT Connection to Ethernet Port on Control Card, Front Panel
Table
11.
Advertisement
Table of Contents
